*** *** *** PLEASE REMEMBER: Always reboot the device first before you proceed with firmware upgrade. *** *** 2006-08-04 Version 1.12R * Added support for MSCHAP, CHAP, MPPE authorization types in PPPoE client. * Added Supported Data Rates option. * Greatly improved QOS features to allow low latency (ie. VOIP) traffic prioritization. * Fixed Site Survey so it correctly shows scanned Access Points that are not broadcasting ESSID. * Please note - if you are using the device in AP mode with QOS enabled it may be necessary to re-enter your QOS entries configuration after upgrade to firmware 1.12R for proper operation. 2006-11-10 Version 1.13R * Added support for Dial on Demand in built in PPPoE Client. * Fixed an error where Site Survey would return blank page under certain circumstances. 2006-11-27 Version 1.13R2 * Fixed low TX Power issue on Hardvare Revision 5 devices. 2007-05-12 Version 1.14R3 * Fixed problem with built in PPtP client not working in NAT Router mode. * Fixed problem with firewall not working properly in NAT Router mode. * Fixed problem with system information screen not showing ethernet port connection speed and status properly. * Added support for new hardware revisions. * Fixed problem reporting signal level in PtP Bridge Mode. 2007-05-18 Version 1.14R4 * Fixed problem which first appeared in 1.14R3 firmware that prevented login into the device WWW interface while operating in AP Client mode. 2007-05-23 Version 1.15R * Fixed problems with system info page not showing properly in certain hardware/software combination settings. * Added support for new hardware revisions.