*** *** PLEASE REMEMBER: Always reboot the device first before you proceed with firmware upgrade. *** 2007-11-16 Version 3.39R - Fixed Site Survey bug. - Fixed signal strength and noise level reporting. - Improved transfer speed and packets per second peformance. - Improved auto rate select algorithm to achieve better performance. -------------------------------------------------------- Should the OSBRiDGE device fail or loose power during firmware upgrade the built-in bootloader allows easy firmware restore. Indication of the device requiring firmware restore is WLAN and Ethernet LEDs blinking subsequentialy for 10 seconds immediately after device power up. Please note however that the LEDs may not always blink when firmware restore is required. The procedure required to perform: 1. You need to obtain tftp server software, the free one is available at http://tftpd32.jounin.net/ 2. Install tftpd32.exe into the catalog where firmware files are located 3. Rename the firmware file into osbridge_5xli.bin 4. Change your computer IP address to 192.168.1.23 netmask 255.255.255.0 5. Connect the OSBRiDGE device to the computer via cross-over cable or via network switch 6. Turn on the OSBRiDGE device, it will initiate the transfer automaticaly, reflash and reboot itself. ---------------------------------------------------------